This article mainly introduces:
Bahrain hydraulic cylinder,servo cylinder manufacturer,servo cylinder
(Bahrain servo cylinder,produced by Hengyu Hydraulic Co., Ltd）
servo cylinder are widely used in Bahrain，because of long service life，smooth movement，high work efficiency.So our company has designed servo cylinder for customers from Bahrain.
The "O" ring can be used as an auxiliary seal inside the servo cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the servo cylinder, and can be completely sealed.
If air enters the hydraulic system, the servo cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.
Protection of the servo cylinder surface: During the dismantling process, safety protection should be carried out on the servo cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the servo cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the servo cylinder should be cleaned up in time.
The servo cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the servo cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the servo cylinder wall due to the stiffness and the weight of the parts, causing scars.
Is it good or bad for the hydraulic cylinder working in the limit stroke position?
It is not good for the hydraulic cylinder working in the limit stroke position. Generally, when the cylinder is used in the limit stroke, the oil in the cylinder will form a backflow back pressure impact on the piston and guide sleeve seals. If the limit is not accurate, it is easy to cause collision damage. It is recommended to leave a buffer of ten to twenty centimeters.
What is the cylinder with rod cavity, what is the rodless cavity.
The rod cavity is the end of the piston rod, the rodless cavity is the end without the piston rod.
Add Wechat